标准光�？�
High-Speed Board-to-Board Connector
Description
High-Speed Board-to-Board Connector
Features
● 0.8mm pin pitch
● Supports 40pin to 140pin
● 5mm to 16mm mated height
● Supports data rate up to 16Gbps
F-tone Networks High-Speed Board-to-Board Connector Selection Table
大宝娱乐 | F-tone Networks
企业邮箱：sales@f-tone.com
企业网站：www.f-tone.com
企业网站：www.sfpgmk.com
企业电话：028-85255257
企业传真：028-85977702
注：本产品有天下产化型号可选
Important Notice
Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement specifications may change without notice.
The publication of information in this data sheet does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.
Related Products
Gen Z毗连器
Gen Z毗连器
Features:
● There are Gen Z, PCle, MCIO options
● 85ohm differential impedance
● Supports data rate up to 64GT/s (Gen6.0)
PCIe 毗连器
PCIe 毗连器
Features:
● There are Gen Z, PCle, MCIO options
● 85ohm differential impedance
● Supports data rate up to 64GT/s (Gen6.0)
OTB TO 3*QSFP28高速线缆
OTB TO 3*QSFP28高速线缆
Features:
● Supports customization
● There are MICO/SLIMLINE/DAC/Riser Cable and other customized solutions
● 28AWG to 34AWG raw cable
ICM集成R J45毗连器
ICM集成R J45毗连器
Features:
● Complies with requirement of IEEE802.3u/802.3ab/802.3bz/802.3an standards
● Supports ganged (1xN) and stacked (2xN) configuration
● Supports Vertical, right angle and slant angle
10G双工LC, 多模850nm VCSEL-LD, PIN 单收,300m光�？�
10G双工LC, 多模850nm VCSEL-LD, PIN 单收,300m光�？�
● Support multi-protocol from 8.5Gb/s to 11.3Gb/s
● 850nm VCSEL laser transmitter
● Duplex LC connector
USB & Type-C
USB & Type-C
Features
● Offers USB2.0(480M), USB3.0(5Gbps). USB3.1(10Gbps) and USB3.2(20Gbps) options
● Offers Type A, Type B, Type C, Mini, Micro options
● Supports Through hole and SMT